Fault finder: Servo and ESC tester

15 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 15 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 15

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Nano resets when the servo moves: what should I check?

Power the servo from its own pack.

Servo twitches: what should I check?

Check the common ground.

OLED blank: what should I check?

Try address 0x3D and check SDA and SCL.