Fault finder: RC car with an ESP-NOW handheld remote

8 checks for this build on the ESP32. Work from the top: power first, then each part, then the code.

0 of 8 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 8

ESP32 supply pin

Plug the ESP32 into USB. Black probe on a GND pin, red probe on the 3V3 pin of the board.

You should see: 3.15 to 3.45 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Nothing happens: what should I check?

Check the car address in the remote.

Car runs on its own: what should I check?

Check the dead zone and fail-safe.

Servo twitches: what should I check?

Use a separate 5 V supply and a common ground.

Motor stalls: what should I check?

Raise the PWM limit slightly and check the battery.