Fault finder: Pi 400 learning desk

11 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 11 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 11

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

No picture: what should I check?

Use the HDMI port next to the USB-C and check the cable.

LED never lights: what should I check?

Flip the LED, check the 330 Ω and the GPIO number.

Button seems stuck: what should I check?

Wires on the wrong side; one leg to GPIO27, the other to GND.

Ribbon cable fits two ways: what should I check?

Red stripe must be at pin 1.

ModuleNotFoundError: what should I check?

gpiozero is preinstalled; check you use python3.