Fault finder: R-2R ladder converter

5 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 5 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 5

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Output stuck at one value: what should I check?

Check the bit wires reach D2 to D5.

Steps are far from expected: what should I check?

Check each 20 kilohm is really two 10 kilohm in series.

Output stays near 0: what should I check?

Check the ground end resistor.

Steps uneven: what should I check?

Resistor tolerance, try other resistors from the bag.

Upload fails: what should I check?

Choose the Old Bootloader option.