Fault finder: QR code attendance scanner
8 checks for this build on the board. Work from the top: power first, then each part, then the code.
0 of 8 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 8
board supply pin
Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
Camera not found: what should I check?
Check the ribbon and that the camera is enabled.
Code not read: what should I check?
Improve the light and the print size.
No beep: what should I check?
Check the buzzer polarity and GPIO18.
Duplicates: what should I check?
Check the repeat time and that the text is identical.
