Fault finder: PWM learning lab with a scope
11 checks for this build on the Uno. Work from the top: power first, then each part, then the code.
0 of 11 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 11
Uno supply pin
Plug the Uno into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
Meter reads nothing: what should I check?
Check the probes are on D9 and GND.
No fade: what should I check?
Check the LED direction and that D9 is used.
Button does nothing: what should I check?
Check D2 and GND.
Meter reading jumps: what should I check?
Switch to a higher PWM frequency.
Servo library does not work: what should I check?
It shares Timer 1, use a different timer.
