Projects / PWM LED dimmer / Fault finder

Fault finder: PWM LED dimmer

9 checks for this build on the Uno. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

Uno supply pin

Plug the Uno into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Brightness jumps or does not change: what should I check?

Check the LED is on a PWM pin marked ~ (3, 5, 6, 9, 10, 11).

raw stuck at 0 or 1023: what should I check?

The wiper is not on A0, or an outer pin is not connected.

Brightness changes backwards: what should I check?

Swap the two outer pins of the potentiometer.