Fault finder: Power outage SMS alert

6 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 6 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 6

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

No SMS arrives: what should I check?

Check the SIM has credit and signal, and that AT+CSQ in the monitor shows 10 or more.

The module keeps restarting: what should I check?

The supply sags when it transmits, so check the 1000 uF capacitor and use the cell, not the Nano 5V pin.

Reading stays at 0 with the adapter on: what should I check?

Check the 10 k divider is joined to the adapter output and to ground.

Garbled text from the module: what should I check?

Check the baud rate is 9600 and the module ground joins the Nano ground.

The Nano resets when the unplug happens: what should I check?

The MT3608 may be set below 5 V, so reset it to 5.0 V.