Projects / Power cut logger / Fault finder

Fault finder: Power cut logger

7 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Nano restarts when the adapter is pulled: what should I check?

The boost converter or cell cannot supply it fast enough. Check the cell charge and the TP4056 wiring.

No file on the SD card: what should I check?

Check CS is on D10, the card is FAT32 and the module is 5 V compatible.

Durations are wrong: what should I check?

The RTC time is not set or its battery is flat.

The TP4056 gets hot: what should I check?

It is charging a cell while powering a load. Keep the cell near 1 A charge and the Nano load small.