Fault finder: Battery life calculator lab for sensor nodes

10 checks for this build on the ESP32. Work from the top: power first, then each part, then the code.

0 of 10 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 10

ESP32 supply pin

Plug the ESP32 into USB. Black probe on a GND pin, red probe on the 3V3 pin of the board.

You should see: 3.15 to 3.45 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Reads zero: what should I check?

Current must pass through VIN+ to VIN-, not around the module.

ESP32 will not start: what should I check?

The module's shunt drops about 0.3 V at 400 mA. Check the load.

Numbers jump: what should I check?

Wi-Fi bursts are short. Average over a whole cycle.

OLED shows nothing: what should I check?

Check I2C addresses and wiring.