Fault finder: Potentiometer puppet

9 checks for this build on the Uno. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

Uno supply pin

Plug the Uno into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Servo jitters: what should I check?

Add a 100 uF capacitor across the servo supply, or use a separate supply.

Uno resets when the servo moves: what should I check?

Too much current from USB, use an external 5 V supply.

Servo does the opposite direction: what should I check?

Swap the two outer pot legs.

Servo hits the end stops and buzzes: what should I check?

Limit the map() range, for example 10 to 170.

Nothing moves: what should I check?

Check the servo signal wire is on D9.