Fault finder: Two knobs, how fine can you set?

11 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 11 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 11

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Screen blank: what should I check?

Try address 0x3D and check SDA and SCL.

Readings far from expected: what should I check?

Enter the real 5V rail in VREF_MV.

Reading jumps: what should I check?

Check the wiper pin, a loose breadboard contact causes jumps.

Cannot reach OK: what should I check?

The window may be too tight for your ADC, widen it to 3 mV.

Both read zero: what should I check?

Check the outer legs are on 5V and GND.