Fault finder: Chair posture monitor
5 checks for this build on the ESP32. Work from the top: power first, then each part, then the code.
0 of 5 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 5
ESP32 supply pin
Plug the ESP32 into USB. Black probe on a GND pin, red probe on the 3V3 pin of the board.
You should see: 3.15 to 3.45 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
Always seated: what should I check?
Raise SEATED or check the dividers.
Never seated: what should I check?
Lower SEATED and check the 3V3 wiring.
Readings drift: what should I check?
Fix the sensors so they cannot slide.
Buzzes too often: what should I check?
Raise the thresholds.
