Fault finder: Two-player Pong on OLED

11 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 11 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 11

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

The screen is blank: what should I check?

Try the address 0x3D, check SDA and SCL, and install both Adafruit libraries.

The ball goes through paddles: what should I check?

Adjust the collision limits: the ball is fast, so lower vx to 1 or check the paddle edge values.

The paddles jitter: what should I check?

Add a 100 nF capacitor from each pot's middle pin to GND.

A paddle moves backwards: what should I check?

Swap the pot's outer wires.