Fault finder: PM2.5 dust monitor with PMS5003

9 checks for this build on the ESP32. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

ESP32 supply pin

Plug the ESP32 into USB. Black probe on a GND pin, red probe on the 3V3 pin of the board.

You should see: 3.15 to 3.45 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Nothing on screen: what should I check?

Swap TX and RX, and check the fan spins (it needs 5 V).

Numbers stuck at 0: what should I check?

The sensor is in standby. Power cycle it.

Readings much higher than the city station: what should I check?

Indoor sources (cooking, incense, dusting) are common. Compare at the same time with windows open.