Fault finder: PIR intruder alarm with arm button

11 checks for this build on the Uno. Work from the top: power first, then each part, then the code.

0 of 11 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 11

Uno supply pin

Plug the Uno into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Alarm goes off as soon as it arms: what should I check?

You were still in view. Lengthen the exit delay or point the sensor away from the door.

False alarms with nobody there: what should I check?

Keep the PIR away from heaters, sunlight and AC vents, and lower its sensitivity.

Button does nothing: what should I check?

Check it spans the breadboard gap and goes to GND.

PIR output stays HIGH for long: what should I check?

Turn the time trimmer fully anticlockwise.