Fault finder: Pinball score counter

11 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 11 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 11

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Library not found: what should I check?

Install TM1637Display.

Display stays blank: what should I check?

Check CLK to D6 and DIO to D7.

A bumper counts twice: what should I check?

Increase the 80 millisecond gap.

A bumper does nothing: what should I check?

Check its wiring to its pin and GND.

LED stays dark: what should I check?

Check its direction and the 220 ohm resistor.