Fault finder: Piggy bank coin counter

11 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 11 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 11

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Counts without a coin: what should I check?

Turn the knob to reduce the range or shade the sensor.

Misses coins: what should I check?

Turn the knob up and aim the sensor across the slot.

Counts a coin twice: what should I check?

Increase LOCKOUT_MS.

Blank screen: what should I check?

Check the OLED wires and try address 0x3D.

Total looks wrong: what should I check?

It is an estimate, so reset and count by hand.