Fault finder: Pico WH comfort page
7 checks for this build on the Pico. Work from the top: power first, then each part, then the code.
0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7
Pico supply pin
Plug the Pico into USB. Black probe on a GND pin, red probe on the 3V3(OUT) pin of the board.
You should see: 3.15 to 3.45 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
Page shows zero: what should I check?
Check the data wire on GP15 and the pull-up resistor.
OSError: what should I check?
Reading too often, or a loose wire, wait and try again.
Wi-Fi does not connect: what should I check?
Check the name and password, and that the network is 2.4 GHz.
Page does not open: what should I check?
Use the exact address from the shell and the same Wi-Fi.
Temperature looks high: what should I check?
Keep the sensor away from the Pico and from heat sources.
