Fault finder: Pico knob voltmeter
11 checks for this build on the Pico. Work from the top: power first, then each part, then the code.
0 of 11 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 11
Pico supply pin
Plug the Pico into USB. Black probe on a GND pin, red probe on the 3V3(OUT) pin of the board.
You should see: 3.15 to 3.45 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
Value stuck at maximum: what should I check?
Check the wiper goes to GP26.
Readings jump: what should I check?
Keep wires short and add 100 nanofarad from GP26 to GND.
Values do not match the meter: what should I check?
Measure 3V3(OUT) and update VREF.
ImportError for ssd1306: what should I check?
Install the micropython-ssd1306 package.
Blank screen: what should I check?
Check the OLED address 0x3C and the GP0 and GP1 wires.
