Fault finder: Pico LED chaser through an I2C expander

9 checks for this build on the Pico. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

Pico supply pin

Plug the Pico into USB. Black probe on a GND pin, red probe on the 3V3(OUT) pin of the board.

You should see: 3.15 to 3.45 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Nothing lights: what should I check?

Check the scan result and the address in the program.

LEDs inverted: what should I check?

Check the LED direction, the pin must be the cathode side.

Wrong order: what should I check?

Swap the LED wires to match P0 to P7.

Dim LEDs: what should I check?

Check each LED has its own resistor and the supply is 3.3 V.

Program does not start on power-up: what should I check?

Save it on the Pico as main.py.