Fault finder: MicroPython on Pico with sensors
11 checks for this build on the Pico. Work from the top: power first, then each part, then the code.
0 of 11 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 11
Pico supply pin
Plug the Pico into USB. Black probe on a GND pin, red probe on the 3V3(OUT) pin of the board.
You should see: 3.15 to 3.45 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
Sensor read failed: what should I check?
Check the pull-up and wiring. The DHT22 needs a 2 second gap between readings.
Thonny cannot find the Pico: what should I check?
MicroPython not installed or a charge-only cable. Use a data cable.
LED does not toggle: what should I check?
Wrong pin number. Pico pin names are GP numbers, not board pin numbers.
Button seems to double-toggle: what should I check?
Increase the debounce delay.
