Fault finder: Pico DAC waveform maker
7 checks for this build on the Pico. Work from the top: power first, then each part, then the code.
0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7
Pico supply pin
Plug the Pico into USB. Black probe on a GND pin, red probe on the 3V3(OUT) pin of the board.
You should see: 3.15 to 3.45 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
No output: what should I check?
Check the printed address and the wiring.
Wave looks coarse: what should I check?
That is the 64 steps, filter it with a resistor and capacitor.
Peak below 3.3 V: what should I check?
The module load or supply is dragging it down.
Button does nothing: what should I check?
Check GP14 to GND.
Program does not start on power-up: what should I check?
Save it on the Pico as main.py.
