Fault finder: Pico LED matrix scrolling sign

7 checks for this build on the Pico. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

Pico supply pin

Plug the Pico into USB. Black probe on a GND pin, red probe on the 3V3(OUT) pin of the board.

You should see: 3.15 to 3.45 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Blank display: what should I check?

Check VCC is on VBUS and the three signal wires are on the right pins.

Letters sideways or mirrored: what should I check?

Your module is wired differently; draw the text into the buffer rotated, or flip the rows when you send them.

Garbled lights: what should I check?

Shorten the signal wires and lower the SPI baudrate.

All LEDs lit: what should I check?

The display test register is on; check the setup lines ran.

Too bright or too dim: what should I check?

Change the 3 in the intensity setting, 0 to 15.