Fault finder: Pico two-sensor thermometer comparison

9 checks for this build on the Pico. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

Pico supply pin

Plug the Pico into USB. Black probe on a GND pin, red probe on the 3V3(OUT) pin of the board.

You should see: 3.15 to 3.45 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Reads very hot or very cold: what should I check?

Check the chips are the right way round, a reversed sensor gets hot.

LM35 reads wrong: what should I check?

Check it has 5 V on VBUS, not 3.3 V.

Both read low: what should I check?

Check the pin order and the wire to the ADC pin.

Difference is large: what should I check?

Let both settle for a minute and keep them together.

Nothing on the display: what should I check?

Check the I2C wires and the address 0x3C.