Fault finder: Pico joystick snake game

9 checks for this build on the Pico. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

Pico supply pin

Plug the Pico into USB. Black probe on a GND pin, red probe on the 3V3(OUT) pin of the board.

You should see: 3.15 to 3.45 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Directions are swapped: what should I check?

Your module may be turned, swap the pins or change the signs in read_direction.

Snake drifts when the stick is at rest: what should I check?

Widen the middle zone, for example 25000 to 40000.

Nothing on the screen: what should I check?

Check the I2C wires and that the OLED address is 0x3C.

ImportError for ssd1306: what should I check?

Install the micropython-ssd1306 package.

Too fast: what should I check?

Raise 160 in the delay line to slow it down.