Fault finder: Pico chip temperature logger

5 checks for this build on the Pico. Work from the top: power first, then each part, then the code.

0 of 5 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 5

Pico supply pin

Plug the Pico into USB. Black probe on a GND pin, red probe on the 3V3(OUT) pin of the board.

You should see: 3.15 to 3.45 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Nothing prints: what should I check?

Run the program from Thonny and look at the shell.

Reading is far from the room temperature: what should I check?

The chip runs warmer, and the sensor is uncalibrated.

NameError: what should I check?

Check the import line for ADC.

Value jumps about: what should I check?

Keep the Pico away from drafts and use the averaging.

Program does not start on power-up: what should I check?

Save it on the Pico as main.py.