Fault finder: Pico distance tape measure

13 checks for this build on the Pico. Work from the top: power first, then each part, then the code.

0 of 13 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 13

Pico supply pin

Plug the Pico into USB. Black probe on a GND pin, red probe on the 3V3(OUT) pin of the board.

You should see: 3.15 to 3.45 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

No echo: what should I check?

Check 5 V on the sensor and the echo divider.

Values jump: what should I check?

Use a flat, hard target and keep wires short.

Pico damaged risk: what should I check?

Never feed the echo straight into a pin, always divide it.

ImportError for ssd1306: what should I check?

Install the micropython-ssd1306 package.

Blank screen: what should I check?

Check the OLED address 0x3C and the GP0 and GP1 wires.