Fault finder: Pico Bluetooth LED panel

7 checks for this build on the Pico. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

Pico supply pin

Plug the Pico into USB. Black probe on a GND pin, red probe on the 3V3(OUT) pin of the board.

You should see: 3.15 to 3.45 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Module does not show up on the phone: what should I check?

Check it has power and the light is blinking, and pair from the phone Bluetooth settings.

No reply on the phone: what should I check?

Check TXD and RXD are crossed, module TX to Pico RX.

Strange characters: what should I check?

Check the baud rate, 9600 for the module as delivered.

iPhone cannot connect: what should I check?

iPhones do not support classic Bluetooth serial, use an Android phone.

LED does not light: what should I check?

Check the LED direction, the long leg goes to the resistor.