Fault finder: Pico clock with temperature

9 checks for this build on the Pico. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

Pico supply pin

Plug the Pico into USB. Black probe on a GND pin, red probe on the 3V3(OUT) pin of the board.

You should see: 3.15 to 3.45 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

OSError: what should I check?

Check SDA and SCL on GP0 and GP1 and that the module has power.

Display blank: what should I check?

Check CLK on GP14, DIO on GP15 and the power wires.

Time resets to 12:00: what should I check?

Fit or replace the backup cell, then set the minutes again.

Temperature is high: what should I check?

The chip reads a little above the room, this is normal.

Digits look wrong: what should I check?

Check CLK and DIO are not swapped.