Projects / Pico lux meter / Fault finder

Fault finder: Pico lux meter

11 checks for this build on the Pico. Work from the top: power first, then each part, then the code.

0 of 11 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 11

Pico supply pin

Plug the Pico into USB. Black probe on a GND pin, red probe on the 3V3(OUT) pin of the board.

You should see: 3.15 to 3.45 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Nothing on the display: what should I check?

Check the I2C wires and that the OLED address is 0x3C.

OSError on the sensor: what should I check?

Check the sensor address 0x23, or 0x5C if the ADDR pin is high.

Reading never changes: what should I check?

Check the sensor window is not covered.

ImportError for ssd1306: what should I check?

Install the micropython-ssd1306 package.

Readings seem low: what should I check?

Face the sensor towards the light and keep shadows off it.