Fault finder: Pico eight-switch reader on three pins

7 checks for this build on the Pico. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

Pico supply pin

Plug the Pico into USB. Black probe on a GND pin, red probe on the 3V3(OUT) pin of the board.

You should see: 3.15 to 3.45 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Always shows some buttons down: what should I check?

Check each input has a 10 kilo-ohm resistor to GND, a floating input reads random.

Buttons in the wrong order: what should I check?

Check which chip pin each button uses, button 1 is pin 14 and button 8 is pin 6.

Nothing ever changes: what should I check?

Check pin 15 is on GND and the load and clock pins are not swapped.

Wrong results: what should I check?

The load pin must go low then high before shifting.

Chip hot: what should I check?

Check pin 16 is on 3.3 V and pin 8 on ground.