Fault finder: Pick to light bin tray

9 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

No LEDs light: what should I check?

Check pin 13 is on GND and pin 10 on 5V.

Wrong LED lights: what should I check?

Check which output feeds which LED and adjust the bin numbers.

Two LEDs light: what should I check?

A wiring error on the data or clock line, so check D11 and D12.

Button skips a step: what should I check?

The debounce wait handles it, check the button wires.

Dim LEDs: what should I check?

Use 220 ohm resistors, not larger.