Fault finder: 3D printer control with a Pi

7 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

octopi.local not found: what should I check?

Use the Pi's address from your router.

Printer will not connect: what should I check?

Choose the right serial port and baud rate (often 115200 or 250000).

Camera black: what should I check?

Reseat the ribbon cable and check the camera is enabled.

Print stutters: what should I check?

Weak power supply or a slow SD card; use the official supply.

API error 403: what should I check?

Wrong or missing key in OCTOPRINT_KEY.