Fault finder: Motion-triggered security camera on Raspberry Pi

8 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 8 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 8

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

No cameras available: what should I check?

The ribbon is in backwards or loose. Reseat it with the Pi powered off.

Records non-stop: what should I check?

The PIR sees a heater, window or pet. Point it elsewhere and lower its sensitivity.

Clips will not play: what should I check?

Install VLC. Some players cannot open the raw stream: the FfmpegOutput used here writes a normal MP4.

Privacy: what should I check?

Tell people a camera is recording, and never point it at a neighbour's home.