Fault finder: Environment display on a Pi

12 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 12 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 12

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

i2cdetect shows nothing: what should I check?

I2C is not enabled or SDA and SCL are swapped.

OSError on start: what should I check?

The BME280 address is 0x77 on your module. Change it in the script.

Display blank: what should I check?

The OLED address is not 0x3C or it is the wrong controller.

Temperature reads high: what should I check?

The Pi's heat warms the sensor. Mount it on a short lead away from the board.