Fault finder: Web control for GPIO
11 checks for this build on the board. Work from the top: power first, then each part, then the code.
0 of 11 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 11
board supply pin
Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
Relay works backwards: what should I check?
Change active_high.
DHT22 errors: what should I check?
Normal now and then; refresh, and check the 10 k pull-up.
Page does not open: what should I check?
Check the Pi address and port 8000.
