Fault finder: Pen plotter with two steppers

7 checks for this build on the Uno. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

Uno supply pin

Plug the Uno into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Motor hums but does not turn: what should I check?

Swap one coil pair of the motor wires.

Drawing is the wrong size: what should I check?

Check the steps per millimetre.

Drivers overheat: what should I check?

Lower the current or add a heatsink and a fan.