Fault finder: Pedestrian crossing light
9 checks for this build on the Nano. Work from the top: power first, then each part, then the code.
0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9
Nano supply pin
Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
A light never comes on: what should I check?
Check its LED direction and the 220 ohm resistor.
Button seems ignored: what should I check?
Check D2 to GND and wait for the minimum green time.
Sequence runs without a press: what should I check?
A loose wire on D2, check the connection.
No beeps: what should I check?
Use a passive buzzer on D8.
Wrong light order: what should I check?
Check the pin numbers against the table.
