Fault finder: Peak detector and hold

10 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 10 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 10

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Hold voltage low by 0.6 V: what should I check?

Take the feedback from the cathode side of the diode, not the op-amp output.

Hold voltage does not rise: what should I check?

Check the diode direction and that pin 3 is the signal.

Hold falls too fast: what should I check?

Use a larger bleed resistor or none.

Reset does nothing: what should I check?

Check the button wiring to the hold node.