Fault finder: ADC and DAC lab on one chip

13 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 13 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 13

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Display blank: what should I check?

Check the OLED address is 0x3C and the wiring.

All values 0 or 255: what should I check?

Check the PCF8591 power and the AIN jumper settings on the board.

AIN3 not following: what should I check?

Check the AOUT to AIN3 wire.

Values jumpy: what should I check?

Add a small capacitor from each input to GND.

Chip not found: what should I check?

Scan the I2C bus and check the address pins.