Fault finder: Eight extra outputs for a bar graph

9 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Not found message: what should I check?

Try 0x38, and check the address pins.

All LEDs always on: what should I check?

The bits are not inverted, check the tilde in the sketch.

LEDs very dim: what should I check?

Normal if wired to source, rewire to sink as shown.

Only some LEDs work: what should I check?

Check each LED direction.

Flicker: what should I check?

Loose breadboard connection on SDA or SCL.