Fault finder: Paddy field water depth sensor

5 checks for this build on the ESP32. Work from the top: power first, then each part, then the code.

0 of 5 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 5

ESP32 supply pin

Plug the ESP32 into USB. Black probe on a GND pin, red probe on the 3V3 pin of the board.

You should see: 3.15 to 3.45 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Reading does not change: what should I check?

The magnet is too far or the wrong pole faces the sensor.

LoRa begin fails: what should I check?

Check the SPI wires, NSS and that the antenna is attached.

No message received: what should I check?

Both ends must use the same frequency and settings.

Battery drains quickly: what should I check?

Make sure the ESP32 goes to deep sleep after sending.