Fault finder: Op-amp comparator light switch

11 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 11 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 11

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

LED never lights: what should I check?

Check pin 2 and pin 3 are not swapped and the LED direction.

LED always on: what should I check?

Reference is too high, turn the pot.

Output stays low: what should I check?

Check the 10 kilohm pull-up to 5 V is fitted.

No hysteresis seen: what should I check?

Check the 100 kilohm goes from pin 1 to pin 3.

Chip warm: what should I check?

Check the supply polarity.