Fault finder: PC stats monitor
9 checks for this build on the Nano. Work from the top: power first, then each part, then the code.
0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9
Nano supply pin
Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
Waiting for PC forever: what should I check?
The port name is wrong or another program holds it. Close the serial monitor.
Bars stuck at zero: what should I check?
The line format is wrong. Each line must be three numbers separated by commas and end with a newline.
Display blank: what should I check?
Check the OLED address 0x3C and wiring.
Script stops after a while: what should I check?
The Nano reset when the port opened. Wait 2 seconds after opening, as in the script.
