Projects / Live Ohm's law plot / Fault finder

Fault finder: Live Ohm's law plot

11 checks for this build on the Uno. Work from the top: power first, then each part, then the code.

0 of 11 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 11

Uno supply pin

Plug the Uno into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

INA219 not found: what should I check?

Check SDA, SCL, power and the address.

Current reads negative: what should I check?

VIN+ and VIN- are swapped.

Noisy reading at 10 kilohm: what should I check?

Small currents are near the chip's limit, use a larger sample.

Resistance far off: what should I check?

Check the resistor colour bands.

Readings jump: what should I check?

A loose breadboard contact, press the parts in.