Fault finder: Offline sensor recorder

11 checks for this build on the ESP32. Work from the top: power first, then each part, then the code.

0 of 11 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 11

ESP32 supply pin

Plug the ESP32 into USB. Black probe on a GND pin, red probe on the 3V3 pin of the board.

You should see: 3.15 to 3.45 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

SD card not found: what should I check?

Card not FAT32, wrong CS, or a 3.3 V-only module on 5 V.

Temperature a few degrees high: what should I check?

Sensor too close to the ESP32: move it away on wires.

Lines missing: what should I check?

Long delays while writing are normal; check the card is not full.