Fault finder: Nucleo serial command console

7 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Nothing appears in the monitor: what should I check?

Check the port, 115200 baud and the board settings.

Commands ignored: what should I check?

Set the line ending to newline.

Built-in LED does nothing: what should I check?

Some boards use an inverted LED, try the opposite state.

External LED dark: what should I check?

Check polarity and that D8 exists on your board.

Garbled text: what should I check?

Set the monitor baud rate to 115200.