Fault finder: nRF24L01 wireless servo remote
10 checks for this build on the Nano. Work from the top: power first, then each part, then the code.
0 of 10 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 10
Nano supply pin
Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
Radio not responding: what should I check?
Check the SPI wires and CE/CSN, and that VCC is 3.3 V.
Always "no ack: what should I check?
Add the 10 µF capacitors, keep the boards at least 1 m apart for the first test, and check both use the same address.
Short range: what should I check?
RF24_PA_LOW is for the bench. Use RF24_PA_HIGH, or the PA+LNA module with an external antenna and its own 3.3 V regulator.
