Fault finder: nRF24 two-way serial link
6 checks for this build on the Nano. Work from the top: power first, then each part, then the code.
0 of 6 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 6
Nano supply pin
Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
Radio not found: what should I check?
Check the wiring, especially MISO and MOSI, and that VCC is 3.3 V.
Random failures: what should I check?
The supply dips. Move the capacitor closer or use a separate 3.3 V regulator.
Messages garbled: what should I check?
Both boards use the same NODE value. They must differ.
Works only on the desk: what should I check?
Raise power with setPALevel, but keep the module 3.3 V only and add the capacitor.
